BJPDN - ISOPAR M, DRY CLEANING SOLVENT

Product Identification

Product ID:ISOPAR M, DRY CLEANING SOLVENT
MSDS Date:06/01/1989
FSC:6850
NIIN:00-295-8011
MSDS Number: BJPDN

Responsible Party
EXXON CO USA, A DIV OF EXXON CORP.
800 BELL ST
HOUSTON, TX 77252-2180
US

Emergency Phone: 713-870-6000

Info Phone: 713-656-2443

Cage: 29700

Contractor
TEXTILE CHEMICAL CO
READING, PA 19605 US

Telephone: 215-926-4151

Cage: 2H096

Ingredients

HYDROTREATED LIGHT PETROLEUM DISTILLATE

CAS: 64742-47-8

Fraction By Weight: 100% %

Hazards

LD50 LC50 Mixture:>5 MG/M3 LD50 ORAL-RAT
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: IRRITATION. RESPIRATORY SYSTEM:
IRRITATION, CENTRAL NERVOUS SYSTEM EFFECTS. SKIN: PROLONGED OR
REPEATED CONTACT MAY CAUSE IRRITATION AND DERMATITIS. LAB ANIMAL
STUDIES HAVE SHOWN THAT PROLONGED AND REPEATED INHALATION EXPOSURE
TO HYDROCARBONS CAN PRODUCE ADVERSE KIDNEY EFFECTS IN MALE RATS.
Explanation of Carcinogenicity:PRODUCT CONTAINS NO MATERIALS CURRENTLY
CLASSIFIED AS CARCINOGENIC BY NTP, IARC OR OSHA.
Effects of Overexposure:EYE IRRITATION, RESPIRATORY TRACT IRRITATION,
HEADACHES, DIZZINESS, ANESTHESIA, DROWSINESS, UNCONSCIOUSNESS,
DEATH. DRY SKIN.
Medical Cond Aggravated by Exposure:SKIN CONTACT MAY AGGRAVATE AN
EXISTING DERMATITIS.

First Aid

First Aid:EYE CONTACT: IF SPLASHED INTO EYES, FLUSH WITH CLEAR WATER
FOR 15 MINUTES OR UNTIL IRRITATION SUBSIDES. IF IRRITATION
PERSISTS, CALL A PHYSICIAN. SKIN: IN CASE OF SKIN CONTACT, REMOVE
ANY CONTAMINATED CLOTHING AND WASH THOROUGHLY WITH SOAPAND WATER.
INHALATION: IF OVERCOME BY VAPOR, REMOVE FROM EXPOSURE AND CALLA
PHYSICIAN IMMEDIATELY. INGESTION: IF INGESTED, DO NOT INDUCE
VOMITING.

Fire Fighting

Flash Point Method:PMCC
Flash Point:160F,71C
Autoignition Temp:Autoignition Temp Text:640F
Lower Limits:0.6 %
Upper Limits:7 %
Extinguishing Media:FOAM, WATER SPRAY "FOG", DRY CHEMICAL, CARBON
DIOXIDE AND VAPORIZING LIQUID TYPE EXTINGUISHING AGENTS.
Fire Fighting Procedures:WATER MAY BE INEFFECTIVE, BUT WATER SHOULD BE
USED TO KEEP FIRE EXPOSED CONYAINERS COOL. IF ALEAK OR SPILL HAS
IGNITED, USE WATER SPRAY TO DISPERSE THE VAPORS.
Unusual Fire/Explosion Hazard:WATER SPRAY MAY BE USED TO FLUSH SPILLS
AWAY FROM EXPOSURES. MINIMIZE BREATHING GASES, VAPOR, FUMES OR
DECOMPOSITION PRODUCTS. USE SUPPLIED-AIR BREATHING EQUIPM

Accidental Release

Spill Release Procedures:SHUT OFF AND ELIMINATE ALL IGNITION SOURCES.
KEEP PEOPLE AWAY. RECOVER FREE PRODUCT. ADD SAND, EARTH OR OTHER
SUITABLE ABSORBENT MATERIAL TO SPILL AREA. MINIMIZE BREATHING
VAPORS. MINIMIZE SKIN CONTAC T. VENTILATE CONFINED SPACES. KEEP OUT
OF WATERWAY
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:THIS LIQUID IS VOLATILE AND GIVES OFF
INVISIBLE VAPORS. EITHER THE LIQUID OR VAPOR MAY SETTLE IN LOW
AREAS OR TRAVEL TO REMOTE IGNITION SOURCES.
Other Precautions:KEEP PRODUCT AWAY FROM IGNITION SOURCES, SUCH AS
HEAT, SPARKS, PILOT LIGHTS, STATIC ELECTRICITY, AND OPEN FLAMES.

Exposure Controls

Respiratory Protection:USE AIR-SUPPLIED RESPIRATORY PROTECTION IN
CONFINED OR ENCLOSED SPACES, IF NEEDED.
Ventilation:USE ONLY WITH VENTILATION SUFFICIENT TO PREVENT EXCEEDING
RECOMMENDED EXPOSURE LIMITS AND/OR EXPLOSIVE LIMITS.
Protective Gloves:CHEMICAL-RESISTANT GLOVES
Eye Protection:SPLASH GOGGLES OR FACE SHIELD
Other Protective Equipment:CHEMICAL-RESISTANT APRON OR OTHER IMPERVIOUS
CLOTHING.
Work Hygienic Practices:MINIMIZE BREATHING VAPOR OR MIST. AVOID
PROLONGED OR REPEATED CONTACT WITH SKIN. REMOVE CONTAMINATED
CLOTHING.
Supplemental Safety and Health
LANDER OR DRY CLEAN CLOTHING BEFORE REUSE. REMOVE CONTAMINATED SHOES
AND THOROUGHLY CLEAN BEFORE REUSE. CLEANSE THOROUGHY AFTER CONTACT.
KEEP CONTAINERS CLOSED WHEN NOT IN USE. DO NOT STORE NEAR HEAT,
SPARKS OR FLAME. EFFECTIVELY GROUND PRODUCT TRANSFER SYSTEM IN
ACCORADANCE WITH NFPA STANDARD FOR PETROLEUM PRODUCTS.

Chemical Properties

HCC:V4
Boiling Pt:B.P. Text:401F,205C
Vapor Pres:<2
Vapor Density:> 5
Spec Gravity:0.79
pH:7
Viscosity:2.46 CP
Evaporation Rate & Reference:< 0.1 (N-BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR WATER-WHITE LIQUID, ESSENTIALLY ODORLESS
Percent Volatiles by Volume:100 %

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS SUCH AS LIQUID CHLORINE,
CONCENTRATED OXYGEN, SODIUM AND/OR CALCIUM HYPOCHLORITE.
Stability Condition to Avoid:KEEP PRODUCT AWAY FROM IGNITION SOURCES,
SUCH AS HEAT, SPARKS, PILOT LIGHTS, STATIC ELECTRICITY AND OPEN
FLAMES.
Hazardous Decomposition Products:FUMES, SMOKE, CARBON MONOXIDE,
ALDEHYDES AND OTHER DECOMPOSITION PRODUCTS, IN THE CASE OF
INCOMPLETE COMBUSTION.

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH ALL APPLICABLE
STATE, LOCAL, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.